How To Remove Honeywell Pro Thermostat. Drill 7/32” holes for drywall. Default security code the default security code for the honeywell pro series thermostat is 1234 heat 0 all off 1 heat stage 1 on
Performing a factory reset on your honeywell thermostat is essentially pulling the plug and starting over. If you don't have access, call our support team. Use the scroll buttons to move to reset.
How To Reset Honeywell Thermostat Pro Series.
Before you do any work with your honeywell thermostat, shut off the circuit breaker. If you don't have access, call our support team. System test system status shaded areas below apply only to th6320u/th6220u or as otherwise noted.
How To Remove A Honeywell Thermostat Basic Thermostat Wiring.
You will find a button that says “menu” on the right side of the home page. Drill holes at marked positions, and then lightly tap supplied wall anchors into the wall using a hammer. The old one just has pins marked 1,2,3,4 connected with red=1, blue=2, yellow=3.
Press And Hold Down The Menu Button For 5 Seconds.
Drill 7/32” holes for drywall. Hi, i'm trying to replace an old honeywell thermostat with a more modern one. Then, use the arrows to set the current time.
Use The Scroll Buttons To Move To Reset.
We got a lot of feedback on the video, and the main question that kept poppin. Level and mark hole positions. If you pull it off incorrectly, you could crack the cover or break the clips that hold it in place, which might force you to replace the thermostat.
It Is Possible By Pressing Either Cancel, Run, Use Schedule, Run Schedule, Cancel Hold, Or Remove Hold Based On Which Honeywell Thermostat Model You Opt For.
You can turn on the backlight by pressing any of the buttons. Position the uwp on wall. On some models, hold the 2nd and 4th blank buttons.