close
close

How To Reset Tire Pressure Sensor 2013 Ram 1500

How To Reset Tire Pressure Sensor 2013 Ram 1500. Preferably set the cruise control to assure this speed. Ram/dodge has tpms data linking receivers in each wheel well area that links data from the individual tire pressure sensor to the vehicle bcm (body control module).

EEEkit Tire Pressure Sensor TPMS for RAM 1500 2500 Jeep
EEEkit Tire Pressure Sensor TPMS for RAM 1500 2500 Jeep from www.walmart.com

There may be an indicator light to alert you of low tire pressure, or you may get a separate alert for each tire or be able to monitor pressure on a display on the dash. Find a place to park and turn off your car completely. When the tire pressure light flashes 3x, release the reset button.

The Sensor Should Be Reset To This Practice.

It's not exactly new technology to use the abs sensor to let you know to check tire pressure. Release the reset button when the tire pressure light flashes 3x. Tpms sensors will learn that your tires are set to the correct pressure through a few drive cycles.

If You Get A Tire Pressure Alert, You Should Check Your Tire Pressure.

The pressure light should start blinking. To reset the tpms to the dodge ram 1500, switch on the ignition before starting the vehicle press and hold down the tpms reset button; Press and hold down the tpms reset button;

Drive Your Car At 50 Mph For 10 Minutes To Reset The Sensor.

Let the vehicle sit off for a minimum of 20 minutes. If the light remains on after adjusting the air pressure then the problem lies at one of the individual sensors located at the valve stems on the rims. You have to take it to a shop and have the tpms system reset to your truck.

Drive The Vehicle Above 15 Mph For At Least 10 Minutes.

This might be all it takes, but if the light is still on…. Drive for [email protected] 50 mph or more. The vehicle will learn each sensor id and turn the tpms light off.

This Action Should Reset The Sensor.

Find a place to park and turn off your car completely. Start the engine and let it run for 20 minutes. Start the engine and let it go for about 20 minutes.

Leave a Reply

Your email address will not be published.