close
close

How To Restart Gas Fireplace Pilot Light

How To Restart Gas Fireplace Pilot Light. If the pilot light does not engage on the first try, you may have to hold down the knob long enough to purge the air out of the gas line. If the fireplace’s ignitor still doesn’t ignite, replace the vent cap.

Gas Fireplace Pilot Light Won T Go Out Lighting Ideas
Gas Fireplace Pilot Light Won T Go Out Lighting Ideas from decorlighting.port-media.org

At end turn pilot/on/off button. Using a flashlight if necessary, note the small pilot gas tube leading from the main gas valve and extending into the burner area; Gas fireplaces have traditionally used a standing pilot light to ignite the flames.

Most Fireplaces, Unless Specified Otherwise In The Manual, Have A Gas Control Knob Which Is Next To A Colored Button.

Keep pushing the button until the pilot light turns on. You may need to press the dial in to turn it and may also need to hold the dial depressed at the ‘pilot’ position for a short while to ensure that the pilot stays alight. Push in the pilot knob, which will then manually send gas into the system.

This Process May Take Several Minutes And Several Attempts.

Push the igniter button once every second until it lights. Gas fireplaces have traditionally used a standing pilot light to ignite the flames. Too little or too much air near the burner;

Press This Button And You Should See The Pilot Light Turn On Whenever You Turn The Gas Control To Start The Gas.

At end turn pilot/on/off button. Depending on how long it’s. Using a flashlight if necessary, note the small pilot gas tube leading from the main gas valve and extending into the burner area;

If The Pilot Does Not Light, Wait 5 Minutes And Try Again.

How to start a gas fireplace and relight the pilot [7 steps] first, turn your gas fireplace’s knob from the “off” to the “pilot” position. Hold down your pilot button for 60 seconds after your pilot burner is lit. After you are sure there is no gas buildup, you can begin the process of relighting your pilot light.

Hold The Pilot Button Down For About 20 Seconds To Give The Thermocouple Time To Heat Up, Then Release It.

If you do this correctly, the pilot light should start as soon as the flame is close enough. This is usually a white or red plastic knob that is on top of the main gas valve. Open valve by pivoting handle to be parallel to gas line.

Leave a Reply

Your email address will not be published.